ri2b-turtle ri-2belastic

These units are designed glue mounts for turtles.  They can also be configured as necklace mounts for gallinaceous birds from quail to capercaillie. They can also be setup with with tubes for harness attachment to raptors.

Specifications

Model Weight Standard Life Lifespan range Dimensions: Diameter x H (mm)
RI-2B 6g 6 months 3-9 months 21 x 8
RI-2B 10g 12 months 9-18 months 24 x 10
RI-2B 15g 24 months 18-30 months 25 x 13

Frequency Range: 138 to 235 MHz.

Transmitter: Crystal controlled two-stage design, pulsed by a CMOS multivibrator.

Pulse Width (standard): 24 milliseconds (ms). Available from 22-30ms.

Pulse Rate (standard): 40 pulses per minute (ppm). Available from 20-120ppm.

Power Output: Set to use available battery power over the required transmitter life.

Housing: The battery and transmitter are encapsulated in an inert waterproof epoxy.

Attachment: A number of mounting options are available, such as an elastic or Dacron line neckloop, tubes for the passage of harness material, or a wire loop for attachment to a necklace. See diagrams above.

Antenna: Stranded stainless steel cable covered with a black nylon coating. One or two layers of shrinkable tubing reinforce the antenna at its base.

Activation: Removing an external magnet starts the transmitter. Replacing it stops the transmitter.

Options

Mortality (suffix “M”): The available delay is 12 hours. The 12 hour delay circuit indicates its activation by increasing the pulse rate from a nominal ~42 ppm to ~75 ppm. After the mortality mode has been triggered, any motion resets the transmitter to the normal pulse rate. This option adds ~0.5g to the finished weight of each transmitter.

Activity (suffix “A”): Every motion event exceeding a preset range of angles generates one extra pulse between the normal pulses. This activity pulse is distinctively shorter (~12 ms) than the normal pulses. This option adds ~0.5g to the finished weight of each transmitter.

Temperature (suffix “T”): An increase or decrease in temperature results in a corresponding increase or decrease in pulse rate. At the standard settings, the pulse rate changes from ~15 ppm at 0°C to ~50 ppm at 40°C. Each transmitter is supplied with a plotted calibration curve. This option adds ~0.05g to the finished weight of each transmitter.

Position (suffix “P”): The pulse rate switches from ~24 ppm to ~50 ppm when the animal changes body position, pivoting the transmitter 10° or more from a preset orientation. This option adds ~0.5g to the finished weight of each transmitter.

 

Photos

Videos

TRANSMITTER TRACKS – Episode 1: Madagascar
Saskatchewan painted turtles
Protecting the Desert Tortoise
60 Minutes: The Race to Save the Tortoise
Rare Pond Turtles Holding Their Own Despite Threats